This is an old revision of the document!
Table of Contents
MyCloud ONE
The MyCloud ONE is designed for one desktop 3.5“ SATA hard drive. It provides safe and secure network storage plus the ability to easily share your digital content with family and friends. Stream content within your local network to any available UPnP-AV and DLNA device (e.g. PS3, iTunes, Windows 7, etc.). Remotely access your files through any internet connected computer or through our free iPhone, iPad and Android apps.
CPU |
|
Memory |
|
Internal hard drive |
|
Front I/O |
|
Rear I/O |
|
Front View
Big LED | |
---|---|
Flashing blue | System is starting up |
Blue | System is running and ready |
Red | System error (system is unable to start up) |
Small LED | |
Flashing orange | HDD access |
Rear View
![]() | Power button |
DC 12V | Power receptacle |
![]() | USB 2.0 host port |
eSATA | eSATA host port |
10/100/10000 | Gigabit Ethernet port |
Reset | System reset button |
Power ON/OFF Procedure
Connect the power supply to your device first and only then plug it into the wall outlet. The system starts up automatically as soon as you plug in the power supply. It takes about 1-2 minutes for the device to go online but the blue system LED will indicate when the system is ready.
To safely turn off the device, press and hold the power button for 3 seconds until the red LED starts flashing. The system will then shut down all services and about 20 seconds later, it will power down.
If for some reason the system is unresponsive, press and hold the power button for 6 seconds to forcefully shut down the system and cut off the power.
HDD Installation
Remove the screws on the bottom of the case, lift up the top of the enclosure and remove the HDD chassis.
Install the hard drive in the HDD chassis and fasten the screws on the sides to hold it in place. Mount the HDD chassis and replace the top enclosure. Fasten the screws at the bottom of the case, place the rubber feet over the screws and stick them on the casing to cover the screws.